P0221: Throttle Position Sensor/Switch B Circuit Range/Performance

What Does The P0221 Code Mean?

The throttle position sensor is a potentiometer that measures the amount of throttle opening. As the throttle is opened, the reading (measured in volts) goes up.

The powertrain control module (PCM) is the main computer controlling the vehicle and it supplies a 5 Volt reference signal to the throttle position sensor (TPS) and usually a ground also. A general measurement is: at idle = .5 Volts; full throttle = 4.5 Volts. If the PCM detects that the throttle angle is greater or less than it should be for a specific RPM, it will set this code. The B refers to a particular circuit, sensor, or area of a particular circuit.

What Are The Symptoms Of The P0221 Code?

Symptoms of a P0221 trouble code could include:

• Malfunction Indicator Lamp (MIL) illumination (Check Engine Light or Service Engine Soon light)
• Intermittent stumble on acceleration or deceleration
• Blows black smoke on acceleration
• No start

What Are The Potential Causes Of The P0221 Code?

A code P0221 may mean that one or more of the following has happened:

• TPS has intermittent open or short internally
• Harness is rubbing and causing an open or short in the wiring
• Bad connection at the TPS
• Bad PCM (less likely)
• Water or corrosion in connector or sensor

How Can You Fix The P0221 Code?

Step 1: If you have access to a scan tool, see what the idle and WOT (wide open throttle) readings are for the TPS. Check if they’re close to the specifications mentioned above. If not, then replace the TPS and re-check.

Step 2: Check for an intermittent open or short in the TPS signal. To do that, you can’t use a scan tool. You’ll need an oscilloscope. The reason is because scan tools take samplings of many different readings over just one or two data lines and can miss an intermittent drop out. Hook up your oscilloscope and watch the signal. It should sweep up and down smoothly with no drop outs or spikes.

Step 3: If no problems were noticed, perform a wiggle test. Do this by wiggling the connector and harness while watching the pattern. Does it drop out? If so, replace TPS and re-check.

Step 4: If you have no TPS signal, check for 5 Volt reference at the connector. If it’s present, check the ground circuit for open or shorts.

Step 5: Make sure the signal circuit isn’t 12V. It should never have battery voltage. If it does, trace circuit for short to voltage and repair.

Step 6: Look for any water in the connector and replace TPS as necessary.

Recommended Parts

Below are some recommended auto parts to help you address the trouble code affecting your vehicle and get it running smoothly again:

>>> 1812089 Throttle Position Sensor
>>> Twippo 372Pcs Waterproof Wire Connectors Kit
>>> ECU
>>> Autel Scanner MaxiCOM MK808S
>>> MakerHawk LCD Handheld Digital Oscilloscope

Note: During the purchasing process, please check carefully whether the part you want to buy fits your car!

Check This Video For Reference

Reference Sources

Technical Service Bulletin for P0221 – Volkswagen