Audi P1544: Throttle Actuation Potentiometer Signal Too High

Is your scanner showing Audi P1544?
No worries. We'll show you what it means and how to deal with it.

Presented by

Randy Worner

00:00/00:00

Audi P1544: Throttle Actuation Potentiometer Signal Too High

OVERVIEW

Severity

High

DIY Difficulty Level

Intermediate

Repair Cost

$100-$1000

Can I Still Drive?

What Does The Audi P1544 Code Mean?

Engine started, battery voltage must be at least 11.5v, all electrical components must be off, parking brake must be engaged (to keep daytime driving lights off), automatic transmission selector must be in park, the exhaust system must be properly sealed between the catalytic converter and the cylinder head, coolant temperature must be at least 80 degrees Celsius, and the ground between the engine and the chassis must be well connected. The signal from the Throttle Position Valve Module to the ECM detected was erratic, non existent or unreliable.

Note:

If the complete throttle valve control module is current-less (e. g. connector disconnected) the throttle valve moves into a particular, specified mechanical position, which signals an increased idle speed with an engine at operating temperature.

If only the Throttle Position (TP) actuator –V60- is current-less, the throttle valve also moves into the specified mechanical position (emergency running gap), however, since Closed Throttle Position (CTP) switch –F60- can still be recognized, an “almost normal idle RPM” is reached via the respective ignition angle retardation.

If the Engine Control Module (ECM) detects a malfunction at Throttle Position (TP) sensor –G69-, Throttle Position (TP) actuator –V60- is switched current-less by the Engine Control Module (ECM) and the throttle valve moves into the specified mechanical position (emergency running gap) again.

Note: Terminal assignment at throttle control module is different in vehicles with and without cruise control. Characteristic: Steering column switch with operating module for cruise control.